LED Wire Display, 2 Distance/ 2 Temperature Sensors Backup System (Valor)
Item Price: $45.00
(Sold Out) (Shipping & handling will be calculated based on the shipping zip code)
Two ultrasonic sensors mount on your bumper with plugs to the control module which snaps in.
Digital shows the distance
One inside and one outside temperature sensors
Show inside and outside temperature when the car moves forward
Left and right cursors show the left and right distance range.
Show distance when the driver puts their vehicle into reverse.
LED with sound alarm
Inside emperature Sensor
Outside Temperature Sensor
Distance Sensor's Style
Sensor's Wire Length
Step 1: Connect the Electric Power
Step 2: Install the Backup Sensors
Open the trunk, on the back of the blanket, find the wires to the back light housing.
Use of a 12 volt multi-meter, Probe the appropriate wiring harness which
heads toward the reverse light connector of the vehicle, looking for the wire
which carries 12 volts + when reverse gear is engaged, and no voltage when
reverse gear is disengaged.
Once you have located the proper reverse light power wire, use a quick
connector to connect the RED wire from the control processer. You do
not need to cut any wire.
Drill four holes in the bumper via provided drilling bit.
Install the insert-style sensors in the bumper.
Run the wires of sensors into the trunk, and plug in the control center.
Connect the power line of control center with the power line of backup light.