PRODUCTS CONTACT WARRANTY SHOPPING CART FAQ
  Backup Sensor System
 Car Rear View Camera
 Wireless LCD Display
 Front & Rear Sensors
 Wireless LED Display
 Wire LED / 4 Sensors
 Wire LED / 2 Sensors
 Sound only / 2 Sensors
 Wire LED / 2+2 Sensors
 
 
Wireless LCD Dislay with 2 Backup Sensors (WXL2)
The wireless LCD display monitor shows the distance in inchesThe package of the WXL2 wireless display backup sensors system
Item Price: $50.00  Placing an order online is easy and secure
(Shipping & handling will be calculated based on the shipping zip code)
Wireless LCD screen with backlit light shows the distance in inches.
No need to layout the wires to connect the display unit.
You can choose the stick-on style sensors to make the installation easy. No need to drill holes.
The system sensors transmit a modulated beam signal which is capable of seeing through fog, rain, smoke, and snow..day or night.
Warning Distance:15" - 90"
It is an easy installation model.
  The Wire Diagram of the WXL2 wireless LCD Display Backup Sensors System
Specification
Display TypeLCD Screen
Display Size2.5"
Detecting Distance15" - 90"
Sensor's StyleStick-on or Drill-in
Sensor's Wire Length8 feet
Power SupplyDC 12V
 
  
Step 1: Connect the Electric Power Step 2: Install the Backup Sensors for
           Insert-In Style Stick-on Style
  • Open the trunk, on the back of the blanket, find the wires to the back light housing.
  • Use of a 12 volt multi-meter, Probe the appropriate wiring harness which heads toward the reverse light connector of the vehicle, looking for the wire which carries 12 volts + when reverse gear is engaged, and no voltage when reverse gear is disengaged. Never use a test light to probe wires.

  • Once you have located the proper reverse light power wire, use a quick connector (included) to connect the RED wire from the control processer. You do not need to cut any wire.
  • Drill two holes through the license plate and the trunk.
  • Install two insert-style sensors with the special housings on the license plate as the picture shown.
  • Run the wires of sensors into the trunk, and plug in the control center.
  • Connect the power line of control center with the power line of backup light.
  • test the system.

    • (Note: The license plate holders are available for the two drill-in sensors version of the backup sensors system. Normally the sensors are in white since most of license plates are in white. They are free of charge. If you need them, please write a request on the comment field when place an order.)

    OR

  • Drill two holes in the bumper via provided drilling bit.
  • Install the insert-style sensors in the bumper.
  • Run the wires of sensors into the trunk, and plug in the control center.
  • Connect the power line of control center with the power line of backup light.