Wireless Systems
Wire Systems
Related Web Sites:
Easy Unique Web 
Car Reverse Sensors Site 
Backup Sensors Shop 
Home Contact Warranty Shopping Cart Checkout
 
Wire Digital Display, Backup Sensors Reversing Aid System Pages:   1  
Digital Read-Out, Backup Two Sensors System (CE0010)

Item Price:$39.00

 Two ultrasonic sensors mount on your bumper with plugs to the module which snaps in.
 Digital and Cursor shows the distance range.
 The system sensors transmit a modulated beam signal which is capable of seeing through fog, rain, smoke, and snow..day or night.
 The device is only activated when the driver puts their vehicle into reverse.
 The system alerts with a variable multitone audio pulse and panel display


Digital Backup Two Sensors System with Car Inside/Outside Temperature Display (CE0024)
(New Release)

Item Price: $45.00

 Two Inster-style ultrasonic sensors install in your bumper or attach on the license plate with special adapter.
 Digital display unit shows the distance range, the side of object, and the car inside/outside temperature .
 The system sensors transmit a modulated beam signal which is capable of seeing through fog, rain, smoke, and snow..day or night.
 The distance range is displayed only when the driver puts their vehicle into reverse.
 The car inside/outside temperature shows constantly.
 The system alerts with a variable multitone audio pulse and panel display

  
Step 1: Connect the Electric Power Step 2: Install the Insert-Style Sensors on the License Plate or Bumper
  • Open the trunk, on the back of the blanket, find the wires to the back light housing.
  • Use of a 12 volt multi-meter, Probe the appropriate wiring harness which heads toward the reverse light connector of the vehicle, looking for the wire which carries 12 volts + when reverse gear is engaged, and no voltage when reverse gear is disengaged. Never use a test light to probe wires.

  • Once you have located the proper reverse light power wire, use a quick connector (included) to connect the RED wire from the control processer. You do not need to cut any wire.
  • Drill two holes through the license plate and the trunk.
  • Install two insert-style sensors with the special housings on the license plate as the picture shown.
  • Run the wires of sensors into the trunk, and plug in the control center.
  • Connect the power line of control center with the power line of backup light.
  • test the system.

    • OR

  • Drill two or four holes in the bumper via provided drilling bit.
  • Install the insert-style sensors in the bumper.
  • Run the wires of sensors into the trunk, and plug in the control center.
  • Connect the power line of control center with the power line of backup light.
About Us | Email Us
© COPYRIGHT - Times International Business Co., 2003. ALL RIGHTS RESERVED.